Well needless to say, i could hardly wait to try it on and when i did i was surprised how "Roomy" it was which is a really good thing for me because i am fairly well endowed and unlike my previous devices of which i have tried almost all of the CB-x000 devices which were all extreemly difficult to get into and wear for extended periods of time (the longest of which was about 4 months), this device is easy to get into. i did however quickly realize that there is one drawback to this device. Because it is made of flat stainless steel rings i found that the ring that locks behind the balls was very uncomfortable as it had a very sharp pinch almost all of the time. i tried to figure out what i could do to it to mitigate the pinching and any potential long term damage that could result. My first thought was to encase it in some heat shrink tubing, but that did not work very well because it was not flexible enough. So i put the device aside until today when i had a chance to get to the hardware store. There i found a simple solution to the problem and it only cost me about forty cents! I picked up a 6 inch piece of 3/8 ID by 9/16 OD vinyl tubing. i tried to slip this on but it was knid of stiff, but i knew the solution was fairly easy to resolve. i placed the tube in a coffee cup and filled it with water and heated it until boiling in the microwave oven and let it set for about 2 minutes to get soft an pliable. It did slip on all the way onto the ring. one thing that I would suggest if you are doing this in the future is to use a little bit of vegetable oil on the stainless steel ring so that the tubing slides on a little more smoothly.
Once i had the tubing on i tried it on and my immediate reaction was perfect! Absolutely on pinching or sharp edges to deal with at all now. So i am now tightly locked in the Spike Cage. i will add more photos and details on my experiance over the next few days
No comments:
Post a Comment